P1218 GMC – Injection Pump Calibration Circuit

P1218 GMC Possible Causes

  • The Powertrain Control Module (PCM) currently has no resistance value
  • The Powertrain Control Module (PCM) cannot read the resistance value

How to Fix GMC P1218 Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Technical Notes

The P1218 code is typically set when the resistance is missing from the PMD or when the system has been disrupted and the ECU is relearning the resistance value. Most of the time, the issue is the missing resistance. Repeatedly cycling the key will relearn the resistance value.

Possible Symptoms

  • Engine light on (or engine service warning light soon)

P1218 GMC Meaning

The Powertrain Control Module (PCM) uses a calibrated resistance inside the injection pump to determine fuel rates. The resistance value is stored in the PCM’s memory. If the PCM’s memory has been disrupted or replaced, the PCM will relearn the resistance value on the next ignition cycle. The code is set when the key is turned on or the engine is running and the PCM does not detect a correct current valid resistance value, or it has determined that it was unable to read the current resistance value.

P1218 VOLKSWAGEN – Cylinder 6 Injector Circuit Short to Positive

P1218 VOLKSWAGEN Possible Causes

  • Faulty fuel injector
  • Fuel injector harness is open or shorted
  • Poor electrical connection in fuel injector circuit

How to Fix Volkswagen P1218 Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

  • Engine light on (or service engine soon warning light)

P1218 VOLKSWAGEN Meaning

Cylinder 6 Injector Circuit Short to Positive is the generic description for Volkswagen P1218 code, but the manufacturer may have a different description for your vehicle model and year. Currently, we don’t have additional information about Volkswagen P1218 OBDII code.

P1219 – Low Blocked CID

P1219 Possible Causes

  • Faulty Injector Driver Module (IDM)
  • Injector Driver Module (IDM) harness is open or shorted
  • Poor electrical connection in Injector Driver Module (IDM) circuit

How is code P1219 repaired?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Technical Notes

Check for broken wires at the Powertrain Control Module (PCM)

Possible Symptoms

  • Engine Light On (or Service Engine Soon Warning Light)

P1219 Meaning

The P1219 code is set when there is a circuit problem between the Powertrain Control Module (PCM) and the Injector Driver Module (IDM).

P1219 AUDI – Cylinder 7 Injector Circuit Short to Positive

P1219 AUDI Possible Causes

  • Faulty fuel injector
  • Fuel injector harness is open or shorted
  • Poor electrical connection in fuel injector circuit

How to Fix P1219 AUDI Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

  • Engine light on (or service engine soon warning light)

P1219 AUDI Meaning

Cylinder 7 Injector Circuit Short to Positive is the generic description for Audi P1219 code, but the manufacturer may have a different description for your vehicle model and year. Currently, we don’t have more information about the Audi P1219 OBDII code.

P1219 BUICK – Throttle Position Sensor Reference Voltage

P1219 BUICK Possible Causes

  • Faulty Throttle Position Sensor (TP)
  • Throttle Position Sensor (TP) harness is open or shorted
  • Poor electrical connection in Throttle Position Sensor (TP) circuit

How to Fix Code P1219 BUICK?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1219 BUICK Meaning

The Throttle Position Sensor (TP) is mounted on the throttle body of the Throttle Actuator Control (TAC) assembly. The sensor is actually 2 individual throttle position sensors in 1 housing. Two separate signal circuits, one low reference circuit and one 5-volt reference circuit are used to connect the TP sensor assembly and the TAC module. The TP sensor signal voltage increases as the throttle opens. The TP sensor signal circuit is pulled up to a 5-volt reference voltage.

P1219 CADILLAC – Throttle Position Sensor Reference Voltage

P1219 CADILLAC Possible Causes

  • Faulty Throttle Position Sensor (TP)
  • Throttle Position Sensor (TP) harness is open or shorted
  • Poor electrical connection in Throttle Position Sensor (TP) circuit

How to Fix P1219 CADILLAC Code?

Start by checking the “Possible Causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

  • Engine Light On (or Service Engine Soon Warning Light)

P1219 CADILLAC Meaning

The Throttle Position Sensor (TP) is mounted on the throttle body of the Throttle Actuator Control (TAC) assembly. The sensor is actually 2 individual throttle position sensors in 1 housing. Two separate signal circuits, one low reference circuit and one 5-volt reference circuit are used to connect the TP sensor assembly and the TAC module. The TP sensor signal voltage increases as the throttle opens. The TP sensor signal circuit is pulled up to a 5-volt reference voltage.

P1219 CHEVROLET – Throttle Position Sensor Reference Voltage

P1219 CHEVROLET Possible Causes

  • Faulty throttle position sensor (TP)
  • Throttle position sensor (TP) harness is open or shorted
  • Poor electrical connection in the throttle position sensor (TP) circuit

How to Fix Code P1219 CHEVROLET?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

  • Engine light on (or engine service warning light soon)

P1219 CHEVROLET Meaning

The throttle position sensor (TP) is mounted on the throttle body of the throttle actuator control (TAC) assembly. The sensor is actually 2 individual throttle position sensors in 1 housing. Two separate signal circuits, one low reference circuit and one 5-volt reference circuit are used to connect the TP sensor assembly and the TAC module. The TP sensor signal voltage increases as the throttle opens. The TP sensor signal circuit is pulled up to a 5-volt reference voltage.

P1219 FORD – CID Stuck Low

P1219 FORD Possible Causes

  • Faulty Injector Driver Module (IDM)
  • Injector Driver Module (IDM) harness is open or shorted
  • Poor electrical connection in the Injector Driver Module (IDM) circuit

How to Fix P1219 FORD Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Technical Notes

Check for broken wires at the Powertrain Control Module (PCM)

Possible Symptoms

  • Engine light on (or engine service warning light soon)

P1219 FORD Meaning

The P1219 code is set when there is a circuit problem between the Powertrain Control Module (PCM) and the Injector Driver Module (IDM).

P1219 GMC – Throttle Position Sensor Reference Voltage

P1219 GMC Possible Causes

  • Faulty throttle position sensor (TP)
  • Throttle position sensor (TP) harness is open or shorted
  • Poor electrical connection in the throttle position sensor (TP) circuit
 

How is GMC Code P1219 Repaired?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

 
 

Possible Symptoms

  • Engine light on (or engine service warning light soon)
 

P1219 GMC Meaning

The throttle position sensor (TP) is mounted on the throttle body of the throttle actuator control (TAC) assembly. The sensor is actually 2 individual throttle position sensors in 1 housing. Two separate signal circuits, one low reference circuit and one 5-volt reference circuit are used to connect the TP sensor assembly and the TAC module. The TP sensor signal voltage increases as the throttle opens. The TP sensor signal circuit is pulled up to a 5-volt reference voltage.

P1219 VOLKSWAGEN – Cylinder 7 injector circuit short to positive

P1219 VOLKSWAGEN Possible Causes

  • Faulty fuel injector
  • Fuel injector harness is open or shorted
  • Poor electrical connection in fuel injector circuit

How to Fix Volkswagen P1219 Code?

Start by checking the “possible causes” listed above. Visually inspect the related wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

  • Engine Light On (or Service Engine Soon Warning Light)

P1219 VOLKSWAGEN Meaning

Cylinder 7 Injector Circuit Short to Positive is the generic description for Volkswagen P1219 code, but the manufacturer may have a different description for your vehicle model and year. Currently, we don’t have further information about Volkswagen P1219 OBDII code.