P1190 AUDI Possible Causes

• Faulty O2 sensor
• O2 sensor harness is open or shorted
• Poor electrical connection in O2 sensor circuit

How to Fix P1190 AUDI Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine light on (or service engine soon warning light)

P1190 AUDI Meaning

Incorrect linear O2 sensor reference voltage signal is the generic description for Audi P1190 code, but the manufacturer may have a different description for your vehicle model and year. Currently, we don’t have more information about the P1190 Audi OBDII code.

P1190 HYUNDAI Possible Causes

• Faulty throttle valve
• Throttle valve wiring harness is open or short-circuited
• Poor electrical connection in the throttle valve circuit
• Faulty engine control module (ECM)

How to Fix P1190 HYUNDAI Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine light on (or engine service warning light soon)

P1190 HYUNDAI Meaning

By operating flaps in the intake passage, the passage at the cylinder intake valve can be narrowed. This reduces airflow. The flaps in the intake passage are controlled by the intake throttle actuator. The duty cycle calculation for the intake passage cut-off can be turned on and off by the intake passage cut-off function switch. If the engine speed and the low idle speed controller demand quantity exceed certain thresholds, the MAF S signal must be above a threshold. If not, the “flap stuck closed” error is recognized. If the engine speed and the control duty cycle exceed certain thresholds, the digital intake passage cut-off switch must be activated. If so, the flap stuck open error is recognized. If the throttle actuator is stuck, engine symptoms will occur: engine stalling while running and failure to start.

P1190 JEEP Possible Causes

• Faulty Throttle Inlet Pressure Sensor (TIP)
• Throttle Inlet Pressure Sensor harness is open or shorted
• Poor electrical connection in the Throttle Inlet Pressure Sensor circuit

How to Fix JEEP P1190 Code?

Start by checking the “Possible Causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine Light ON (or Service Engine Soon Warning Light)

P1190 JEEP Meaning

The Powertrain Control Module (PCM) monitors the Throttle Inlet Pressure Sensor (TIP). The PCM sets the Diagnostic Trouble Code (DTC) when it detects a low signal from the Throttle Inlet Pressure Sensor.

P1190 KIA Possible Causes

• Faulty throttle valve
• Throttle valve wiring harness is open or short-circuited
• Poor electrical connection in the throttle valve circuit
• Faulty engine control module (ECM)

How to Fix P1190 KIA Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine light on (or engine service warning light soon)

P1190 KIA Meaning

By operating flaps in the intake passage, the passage at the cylinder intake valve can be narrowed. This reduces airflow. The flaps in the intake passage are controlled by the intake throttle actuator. The duty cycle calculation for the intake passage cut-off can be turned on and off by the intake passage cut-off function switch. If the engine speed and the low idle controller demand quantity exceed certain thresholds, the MAF S signal must be above a threshold. If not, the “flap stuck closed” error is recognized. If the engine speed and the control duty cycle exceed certain thresholds, the intake passage cut-off digital switch must be activated. If so, the flap stuck open error is recognized. If the throttle actuator is stuck, engine symptoms will occur: engine stalling while running and failure to start.

P1190 VOLKSWAGEN Possible Causes

• Faulty O2 sensor
• O2 sensor harness is open or shorted
• Poor electrical connection in O2 sensor circuit

How to Fix P1190 VOLKSWAGEN Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine light on (or service engine soon warning light)

P1190 VOLKSWAGEN Meaning

Incorrect linear O2 sensor reference voltage signal is the generic description for Volkswagen P1190 code, but the manufacturer may have a different description for your model and vehicle year. Currently, we have no further information about Volkswagen P1190 OBDII code.

P1191 Possible Causes

• Faulty Electronic Throttle System (ETS) motor
• Faulty Electronic Throttle System (ETS)
• Electronic Throttle System (ETS) unit
• Electronic Throttle System (ETS) harness is open or shorted
• Poor electrical connection in Electronic Throttle System (ETS) circuit

How is P1191 Code Repaired?

Start by checking the “possible causes” listed above. Visually inspect the corresponding cable harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine light on (or engine service warning light soon)

P1191 Meaning

The Electronic Throttle System (ETS) consists of an ETS unit, ETS motor, Accelerator Pedal Position Sensor (APS), Throttle Position Sensor (TPS), and Limp home valve.
Among the parts mentioned above, the Limp home valve is fixed under the throttle body and helps air flow from the outside through this valve into the engine combustion chamber to prevent the vehicle from stalling the engine when the Powertrain Control Module (PCM) detects an ETS system malfunction.

How to Fix P1191 FORD Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine light on (or engine service warning light soon)

P1191 FORD Meaning

Key Line Voltage is the generic description for Ford code P1191, but the manufacturer may have a different description for your vehicle model and year. Currently, we do not have more information about the Ford P1191 OBDII code.

P1191 HYUNDAI Possible Causes

• Faulty Electronic Throttle System (ETS) motor
• Faulty Electronic Throttle System (ETS)
• Electronic Throttle System (ETS) unit
• Electronic Throttle System (ETS) harness is open or shorted
• Poor electrical connection in Electronic Throttle System (ETS) circuit

How to Fix P1191 HYUNDAI Code?

Start by checking the “Possible Causes” listed above. Visually inspect the corresponding cable harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine Light On (or Service Engine Soon Warning Light)
• Engine Limp Mode (Fail-Safe Mode)

P1191 HYUNDAI Meaning

The Electronic Throttle System (ETS) consists of an ETS unit, ETS motor, Accelerator Pedal Position Sensor (APS), Throttle Position Sensor (TPS), and Limp Home valve.
Among the parts mentioned above, the Limp Home valve is fixed under the throttle body and helps air flow from the outside through this valve to the engine combustion chamber to prevent the vehicle from stalling when the Powertrain Control Module (PCM) detects an ETS system malfunction.

Electronic Throttle System (ETS) 2004 Hyundai Santa Fe

P1191 KIA Possible Causes

• Faulty Electronic Throttle System (ETS) motor
• Faulty Electronic Throttle System (ETS)
• Electronic Throttle System (ETS) unit
• Electronic Throttle System (ETS) wiring harness is open or short-circuited
• Poor electrical connection in the Electronic Throttle System (ETS) circuit

How to Fix P1191 KIA Code?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Check Engine Light on (or Engine Warning Light soon on)
• Engine Limp Mode (Fail-Safe Mode)

P1191 KIA Meaning

The Electronic Throttle System (ETS) consists of an ETS unit, ETS motor, Accelerator Position Sensor (APS), Throttle Position Sensor (TPS), and a Limp Home Valve.
Among the parts mentioned above, the Limp Home Valve is mounted under the throttle body and helps air flow from the outside through this valve into the engine combustion chamber to prevent the vehicle from stalling when the Powertrain Control Module (PCM) detects a malfunction in the ETS system.

P1192 Possible Causes

• Faulty Electronic Throttle System (ETS) motor
• Faulty Electronic Throttle System (ETS)
• Electronic Throttle System (ETS) unit
• Electronic Throttle System (ETS) harness is open or shorted
• Poor electrical connection in Electronic Throttle System (ETS) circuit

How to Fix Code P1192?

Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector pins.

Possible Symptoms

• Engine light on (or service engine soon warning light)

P1192 Meaning

The Electronic Throttle System (ETS) consists of an ETS unit, ETS motor, Accelerator Pedal Position Sensor (APS), Throttle Position Sensor (TPS), and a Limp home valve.
Among the parts mentioned above, the Limp home valve is mounted under the throttle body and helps air flow from the outside through this valve into the engine combustion chamber to prevent the vehicle from stalling the engine when the Powertrain Control Module (PCM) detects an ETS system malfunction.