Symptoms
Symptoms of a P213C engine code may include:
- Malfunction Indicator Light (MIL) illuminated
- Active post-treatment regeneration time longer than normal (it will take more time for the exhaust system to heat up and burn off the soot accumulated inside the diesel particulate filter / catalytic converter)
Causes
Possible causes for this code definition are:
- Short circuit to voltage, ground, or other fault in the EGR throttle control valve signal circuit
- Faulty EGR throttle control valve – internally shorted
- Failed PCM – unlikely
Diagnostic and Repair Procedures
A good starting point is always to check the Technical Service Bulletins (TSBs) for your specific vehicle. Your issue might be a known problem with a published fix from the manufacturer, which can save you time and money during diagnosis.
Next, locate the EGR throttle control valve on your specific vehicle. This valve is located between the intake manifold and the air filter, similar to a throttle body. Once located, visually inspect the connectors and wiring. Look for scratches, rubbing, exposed wires, burns, or melted plastic. Disconnect the connectors and carefully inspect the terminals (the metal parts) inside the connectors. Check if they appear burnt or have a greenish tint indicating corrosion. Use electrical contact cleaner and a plastic-bristled brush if terminal cleaning is necessary. Allow it to dry and apply dielectric silicone grease where the terminals make contact.
If you have a scan tool, clear the diagnostic codes from memory and see if this code returns. If it does not, the connections were likely your problem.
If the P213C code returns, we will need to test the EGR throttle control valve and its associated circuits. Typically, there are 3 or 4 wires at the EGR throttle control valve. Disconnect the harness going to the EGR throttle control valve. With a digital voltmeter (DVOM), test the EGR throttle control valve signal circuit (red lead to the valve signal circuit, black lead to a good ground). If there is no 5 volts at the valve, or if you see 12 volts at the valve, repair the wiring from the PCM to the valve, or possibly a faulty PCM.
If that checks out, ensure there is a good ground at the EGR throttle control valve. Connect a test light to the positive 12V battery terminal (red terminal) and touch the other end of the test light to the ground circuit going to the EGR throttle control valve circuit ground. If the test light does not illuminate, this would indicate a circuit problem. If it lights up, wiggle the wiring harness going to the EGR throttle control valve to see if the test light flickers, indicating an intermittent connection.
If all previous tests pass and you continue to get a P213C, this would most likely indicate a failing EGR throttle control valve, although a faulty PCM cannot be ruled out until the EGR throttle control valve has been replaced.