How serious is this DTC?
A stored P2050 code should be considered serious and addressed as soon as possible. The SCR system could be disabled because of this. Catalyst damage could occur if the conditions that contributed to the code being stored are not corrected in a timely manner.
What are some of the symptoms of the code?
Symptoms of a P2050 trouble code may include:
- Decreased engine performance
- Excessive black smoke from vehicle exhaust
- Reduced fuel efficiency
- Other SCR-related codes
What are some common causes of the code?
Causes of this code may include:
- Faulty reductant injector valve
- Open or shorted circuits in the reductant injector valve control
- Insufficient DEF in the tank
- Faulty SCR controller/PCM or programming error
What are the troubleshooting steps for P2050?
You will need access to a diagnostic scanner, a digital volt/ohmmeter (DVOM), and a source of vehicle-specific diagnostic information to diagnose a P2050 code.
If you can find a technical service bulletin (TSB) that matches the vehicle’s year, make, and model; as well as the engine size, stored code(s), and presented symptoms, it could provide useful diagnostic information.
You’ll want to start your diagnosis with a visual inspection of the reductant heater system harnesses and connectors. Burned or damaged wiring and/or connectors should be repaired or replaced before continuing.
Proceed by hooking up the scanner to the vehicle’s diagnostic connector and retrieving all stored codes and relevant freeze frame data. Note this information before clearing the codes and test drive the vehicle until the PCM enters readiness mode or the code resets.
The code is intermittent and may be much more difficult to diagnose (for the time being) if the PCM enters readiness mode. If this is the case, the conditions that contributed to the code being stored may need to worsen before an accurate diagnosis can be made.
If the code resets, consult your vehicle information source for diagnostic flowcharts, connector pinout diagrams, connector face views, as well as component testing procedures and specifications. This information will be needed to complete the next step of your diagnosis.
Use the DVOM to test the SCR control system power supply. Test fuses with the circuit loaded to avoid misdiagnosis. If proper power and ground circuits are detected, use the scanner to activate the reductant injector valve (solenoid) and test the output control circuit voltage. If voltage is insufficient, suspect the controller is faulty or has encountered a programming error.
If the voltage output circuit is within parameters, use the DVOM to test the reductant injector valve in question. If the valve does not meet manufacturer specifications, suspect it has failed.
The reductant injector valve is actually a solenoid injector that sprays reductant fluid into the exhaust