P1106 DODGE Possible Causes
- Check mechanical condition
- Hoses and tubes
- Vacuum supply to overboost solenoid
- Wastegate actuator failure
- Faulty turbocharger
How to Fix P1106 DODGE Code?
Start by checking the “possible causes” listed above. Visually inspect the corresponding wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
When is the Code Detected?
The ECM did not detect sufficient variance between the TIP sensor signal and BARO pressure signal during turbo boost mode
Symptoms
Possible
Engine light on (or engine service warning light soon)
Engine rough idle
Engine hesitation
P1106 DODGE Meaning
The Barometric Pressure Sensor (BARO) converts atmospheric pressure into a voltage signal that the ECM uses to modify the base fuel injection pulse width